Duroxite™ is designed to be hard, without giving you a hard time in the workshop.

Even the most worn-out equipment can be rebuilt and repaired to perform as new. With our broad product offering, including Hardox® wear plate and Duroxite™, and top-of-the-line processing equipment, you are able to restore products of practically any condition, size and design.

INSTALLING DUROXITE™

No special equipment is needed to install Duroxite™ products. Welding and bolting are the common methods for installing Duroxite™ overlay plate or wear parts onto your equipment.

When joining base metal use 480 MPa (70 ksi) or 560 MPa (80 ksi) consumables. Any surface exposed to severe wear should be protected with hard-surfacing consumables. Cap welding a Duroxite™ product with Duroxite™ Wire ensures the weld will have the same wear resistance, resulting in a consistent service life for the entire overlay product.

CUTTING DUROXITE

Duroxite™ can be cut by plasma, laser, water jet, arc gouge, and abrasive saw cutting. It cannot be cut by oxy-fuel flame cutting. Duroxite™ should be cut from the base metal side only to avoid carbon contamination. When beveling, Duroxite™ overlay plate can be burned from the hard side. Cutting speeds need to be reduced when cutting carbides.